Operation Manual - VLAN
Quidway S3000-EI Series Ethernet Switches Chapter 3
GARP/GVRP Configuration
Huawei Technologies Proprietary
3-3
N Hold timer,
a eave timer should be grea f Join timer and
maller than the Leaveall timer value. Otherwise, the system will prompt message of
error.
3.1.3 Disp nd Debug GARP
onfiguration. Execute
to reset the configuration of GARP. Execute debugging
ug the configuration of GARP.
ote that, the value of Join timer should be n
nd the value of L
o less than the doubled value of
ter than the doubled value o
s
By default, Hold timer is 10 centiseconds, Join timer is 20 centiseconds, Leave timer is
60 centiseconds, and LeaveAll timer is 1000 centiseconds.
lay a
After the above configuration, execute display command in any view to display the
running of GARP configuration, and to verify the effect of the c
reset command in user view
command in user view to deb
Table 3-2 Display and debug GARP
Operation Command
Display GARP statistics information
display garp statistics [ interface
interface-list ]
Display GARP timer
display garp timer [ interface
interface-list ]
Clear GARP st rmation
reset garp [ interface
atistics info
statistics
interface-list ]
Enable GARP event debugging
debugging garp event
Disable GARP event debugging
undo debugging garp event
3.2 Conf
3.2.1 GVRP Overview
GARP VLAN Registration Protocol (GVRP) is a GARP application. Based on GARP
GVRP provides maintenance of the dynamic VLAN registration
agates the information to other switches. All the
GVRP-supporting switches can receive VLAN registration information from other
amically update the local VLAN registration information including the
active members and through which port those members can be reached. All the
igure GVRP
operating mechanism,
information in the switch and prop
switches and dyn
GVRP-supporting switches can propagate their local VLAN registration information to
other switches so that the VLAN information can be consistent on all GVRP-supporting
devices in one switching network. The VLAN registration information propagated by
GVRP includes both the local static registration information configured manually and
the dynamic registration information from other switches.