Operation Manual - Integrated Management
Quidway S3000-EI Series Ethernet Switches Chapter 2
HGMP V2 Configuration
Huawei Technologies Proprietary
2-21
 Note:
[Quidway-Ethernet1/1] ntdp enable
# Run the cluster function.
[Quidway] cluster enable
Upon the completion of the above configurations, you can use the cluster switch-to
ress H-H-H } command to switch to the member device view
resume the administrator device view. To reset a member
device through the administrator device, use the reboot member { member-num |
mac-address eraseflash d. For detailed information about these
{ member-num | mac-add
to maintain and manage the member devices, and use the cluster switch-to
administrator command to
H.H.H } [ ] comman
configurations, refer to the preceding description of this chapter.
To Next Page
Loading...
Need help?
General