Operation Manual - Security
Quidway S3000-EI Series Ethernet Switches Chapter 1
802.1x Configuration
Huawei Technologies Proprietary
1-6
view, only if you enable
this feature on a n this configuration take ef ort.
1.2.5 Settin
T be
s port. When no port is specified,
upplicants.
globally enabling proxy user detection and control in system
specific port ca fects on the p
g the Supplicant Number on a Port
he following commands are used for setti
pecified
ng num r of users allowed by 802.1x on
all the ports accept the same number of
s
Perform the following configurations in system view or Ethernet port view.
Table 1-5 Setting the maximum number of users via a specified port
Operation Command
Set maximum number of users via
specified port
dot1x max-user user-num
[ interface interface-list ]
ber
Restore the maximum number of users
on the port to the default value
und
inter
o dot1x max-user [ interface
face-list ]
By default, 802.1x allows up to 256 supplicants on each port for S3000-EI Series
Ethernet switche
s.
1.2.6 Setting the Authenticat
an set 802.1x to
disable the swi r ID authentication o the following
c
P wing configurations in syste
T C
ion in DHCP Environment
If in DHCP environment the users configure static IP addresses, you c
tch to trigger the use ver them with
ommand.
erform the follo
m view.
able 1-6 Setting the Authentication in DH P Environment
Operation Command
Disable the switch to trigger the user ID
in DHCP environment
authentication over the users who configure
static IP addresses
dot1x dhcp-launch
Enable the switch to trigger the authentication
dhcp-launch
over them
undo dot1x
atic IP addresses in DHCP environment.
1.2.7 Con .1x User
The following commands can be used to configure the authentication method for
802.1x user. Three kinds of methods are available: PAP authentication (RADIUS server
By default, the switch can trigger the user ID authentication over the users who
configure st
figuring the Authentication Method for 802
To Next Page
Loading...
Need help?
General