Operation Manual - Security
Quidway S3000-EI Series Ethernet Switches Chapter 1
802.1x Configuration
Huawei Technologies Proprietary
1-16
user name. Normally, if the user’s
traffic is less than 2kbps consistently over 20 minutes, he will be disconnected.
et the encryption key as “name” when the system
ADIUS server and “money” when the
system exchanges packets with the accounting RADIUS server. Configure the system
to retransmit pa RADIUS server if no respo in 5 seconds.
R
r e RADIUS The system is
in he
domai
T
lo text). The idle cut fu ed.
II.
accessed, the domain name does not follow the
A server group, consisting of two RADIUS servers at 10.11.1.1 and 10.11.1.2
respectively, is connected to the switch. The former one acts as the
primary-authentication/secondary-accounting server. The latter one acts as the
primary-accounting server. S
exchanges packets with the authentication R
ckets to the nse received
etransmit the packet no more than 5 time
eal-time accounting packet to th
s in all. Configure the system to transmit a
server every 15 minutes.
structed to transmit the user name to t
n name.
RADIUS server after removing the user
he user name of the local 802.1x acces
calpass (input in plain
s user is localuser and the password is
nction is enabl
Networking diagram
Supplicant
Authentication Servers
(RADIUS Server Cluster
IP Address: 10.11.1.1
10.11.1.2)
Internet
Authenticator
Switch
Supplicant
Authentication Servers
(RADIUS Server Cluster
IP Address: 10.11.1.1
10.11.1.2)
Internet
Authenticator
Switch
Supplicant
Authentication Servers
(RADIUS Server Cluster
IP Address: 10.11.1.1
10.11.1.2)
Internet
Authenticator
E0/1
Switch
Supplicant
Authentication Servers
(RADIUS Server Cluster
IP Address: 10.11.1.1
10.11.1.2)
Internet
Authenticator
Switch
Supplicant
Authentication Servers
(RADIUS Server Cluster
IP Address: 10.11.1.1
10.11.1.2)
Internet
Authenticator
Switch
II
Figure 1-2 Enabling 802.1x and RADIUS to perform AAA on the supplicant
I. Configuration procedure
Note:
The following examples concern most of the AAA/RADIUS configuration commands.
For details, refer to the chapter AAA and RADIUS Protocol Configuration.
The configurations of accessing user workstation and the RADIUS server are omitted.
To Next Page
Loading...
