Operation Manual - Multicast
Quidway S3000-EI Series Ethernet Switches Chapter 2
IGMP Snooping Configuration
Huawei Technologies Proprietary
2-6
will transmit the specific query message to that port and starts a maximum response
Perform the following configuration in system view.
it
timer.
Table 2-4 Configure aging time of the multicast member
Operation Command
Configure aging time of the multicast
member
igmp-snooping host-aging-time
seconds
Restore the default setting undo igmp-snooping host-aging-time
By default, the aging time of the multicast member is 260 seconds.
2.2.5 Enabling/Disabl nction of fast removing a port from a
multicast g
Normally, at the receiving of the IGMP Leave packet, igmp-snooping sends out
g stead of dire
fter waiting for a period of time, if it receives no respond, igmp-snooping then
command,
ly at receiving the
e user
ollowing configuration in Ethernet port view.
ing the fu
roup
roup-specific query packet in ctly removing a port from a multicast group.
A
removes the port form the group. By configuring the follwing
igmp-snooping removes the port from the multicast group direct
IGMP Leave packet. The fast remove function saves bandwidth when only on
remaining at the port.
Perform the f
Table 2-5 Enabling/Disabling the function of fast removing a port from a multicast
group
Operation Command
Enable the function of fast removing
a port from a multicast group
igmp-snooping fast-leave
Disable the function of fast
a port from a multicas
removing
t group
undo igmp-snooping fast-leave
By default, the fast remove function is disabled.