Step 10 Restart member switches in batches.
# Run the cluster-member reboot group-by member-number 2 to 3 command on the
administrator switch to restart Member-2 and Member-3.
[HUAWEI_0.Administrator-1] cluster
[HUAWEI_0.Administrator-1-cluster] cluster-member reboot group-by member-number 2
to 3
Info: This command will take members reboot.
Are you sure?[Y/N]y
Step 11 Verify the configuration.
Run the display member-reboot-stat command on administrator switch to check the restart
status of the member switches, and you can view that success is displayed, which indicates that
the specified member switches are restarted successfully.
[HUAWEI_2.Member-2] display member-reboot-stat
The result of member switchs rebooting:
------------------------------------------------------------------------
SN Device MacAddress IPAddress Result
------------------------------------------------------------------------
1 S5700 0003-0003-0003 10.0.0.3 success
2 S5700 0004-0004-0004 10.0.0.4 success
----End
Configuration Files
l Configuration file of Administrator-1.
#
sysname Administrator-1
#
vlan batch 10
#
cluster enable
ntdp enable
ntdp hop 3
ntdp timer 10
ndp enable
#
interface Vlanif10
ip address 1.0.0.1 255.0.0.0
#
interface GigabitEthernet0/0/1
port link-type trunk
port trunk allow-pass vlan 10
ntdp enable
ndp enable
#
interface GigabitEthernet0/0/2
port link-type trunk
port trunk allow-pass vlan 10
ntdp enable
ndp enable
#
interface GigabitEthernet0/0/3
port link-type trunk
port trunk allow-pass vlan 10
#
cluster
mngvlanid 10
ip-pool 10.0.0.1 255.0.0.0
build HUAWEI
cluster-ftp-nat enable
ftp-server 2.0.0.1
sftp server 2.0.0.2
Quidway S5700 Series Ethernet Switches
Configuration Guide - Network Management 3 HGMP Configuration
Issue 01 (2011-10-26) Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
176
To Next Page
Loading...
Need help?
General
