EasyManuals Logo

Huawei Quidway S5700 Series User Manual

Huawei Quidway S5700 Series
415 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #73 background imageLoading...
Page #73 background image
2.4.1 Clearing LLDP Statistics
To clear LLDP statistics, run the following reset command in the user view.
Procedure
l Run the reset lldp statistics [ interface interface-type interface-number ] command to
clear LLDP statistics.
----End
2.4.2 Monitoring LLDP Status
To view LLDP status, run the following display commands.
Procedure
l Run the display lldp local [ interface interface-type interface-number ] command to view
LLDP status in the entire system or on an interface.
l Run the display lldp statistics [ interface interface-type interface-number ] command to
view statistics about packets sent and received on an interface.
l Run the display lldp neighbor [ interface interface-type interface-number ] command to
view neighbor information of an interface.
----End
2.5 Configuration Examples
This section provides LLDP configuration examples.
2.5.1 Example for Configuring LLDP on the Device That Has a
Single Neighbor
After LLDP is configured on the network devices, the NMS can obtain the network topology.
The following example describes how to configure LLDP on the devices that have a single
neighbor.
Networking Requirements
As shown in Figure 2-7, SwitchA is directly connected to SwitchB and media endpoint (ME).
The NMS needs to obtain Layer 2 information about SwitchA, SwitchB, and ME. By using the
Layer 2 information, a network administrator can know the detailed network topology
information and configuration conflicts. These requirements can be met by configuring LLDP
on SwitchA and SwitchB.
In addition, the administrator requires that SwitchA and SwitchB send LLDP traps to the NMS
when the LLDP management address changes, global LLDP is enabled or disabled, or the
neighbor information changes. This ensures that the administrator detects topology changes in
time.
The ME supports the LLDP function. Reachable routes exist between the NMS and Switches.
The SNMP parameters are set on all devices.
Quidway S5700 Series Ethernet Switches
Configuration Guide - Network Management 2 LLDP Configuration
Issue 01 (2011-10-26) Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
62

Table of Contents

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Huawei Quidway S5700 Series and is the answer not in the manual?

Huawei Quidway S5700 Series Specifications

General IconGeneral
CategorySwitch
Operating Temperature0°C to 45°C
Relative Humidity5% to 95% (non-condensing)
SeriesQuidway S5700
Forwarding PerformanceUp to 96 Mpps
Ports24 or 48 x 10/100/1000Base-T ports
Power SupplyAC or DC
Storage Temperature-40°C to 70°C
Fixed GE Ports24 or 48
Uplink Ports4 x GE SFP ports
Routing ProtocolsRIP, OSPF, BGP
ManagementSNMP, RMON, CLI, Web
VLAN4094 VLANs
PoEOptional

Related product manuals