EasyManuals Logo

Huawei Quidway S5700 Series User Manual

Huawei Quidway S5700 Series
415 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #227 background imageLoading...
Page #227 background image
The IP address of the NTP server is configured.
Step 2 is optional. If source-interface is specified in Step 3, use it preferentially.
ip-address is the IP address of the NTP server. It can be the IP address of the host
rather than a broadcast address, a multicast address, or the IP address of the reference
clock.
NOTE
When the unicast NTP server is specified, the local switch functions as the client automatically.
The server needs to be configured with only a primary clock.
l (Optional) Configuring the Source Interface for the NTP Server to Send NTP Packets
Do as follows on the switch working as a client:
1. Run:
system-view
The system view is displayed.
2. Run:
ntp-service source-interface vlanif vlan-id
The local source interface that sends NTP packets is specified.
Commonly, specify the IP address of the NTP server on the client. The client and
server can then exchange NTP packets using this IP address
If the source interface to send NTP packets is specified on the server, the IP address
of the server configured on the client should be the same; otherwise, the client cannot
process NTP packets sent from the server and clock synchronization fails.
----End
4.3.4 Configuring the Peer Mode
This part describes how to configure the NTP peer mode. In this mode, clocks on the two peers
synchronize with each other. Each side can send the clock synchronization request message to
the peer and reply the clock synchronization request message from the peer.
Procedure
l Configuring the NTP Symmetric Active End
1. Run:
system-view
The system view is displayed.
2. (Optional) Run:
ntp-service source-interface vlanif vlan-id
The local source interface that sends NTP packets is specified.
3. Run:
ntp-service unicast-peer ip-address [ version number | authentication-
keyid key-id | source-interface interface-type interface-number |
preference ] *
The NTP peer is configured.
Quidway S5700 Series Ethernet Switches
Configuration Guide - Network Management 4 NTP Configuration
Issue 01 (2011-10-26) Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
216

Table of Contents

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Huawei Quidway S5700 Series and is the answer not in the manual?

Huawei Quidway S5700 Series Specifications

General IconGeneral
CategorySwitch
Operating Temperature0°C to 45°C
Relative Humidity5% to 95% (non-condensing)
SeriesQuidway S5700
Forwarding PerformanceUp to 96 Mpps
Ports24 or 48 x 10/100/1000Base-T ports
Power SupplyAC or DC
Storage Temperature-40°C to 70°C
Fixed GE Ports24 or 48
Uplink Ports4 x GE SFP ports
Routing ProtocolsRIP, OSPF, BGP
ManagementSNMP, RMON, CLI, Web
VLAN4094 VLANs
PoEOptional

Related product manuals