Procedure
Step 1 Run the display nqa-agent [admin-name test-name ] [ verbose ] to view the status of the test
instance configured on the NQA client.
----End
Example
<Quidway> display nqa-agent
nqa test-instance a a
test-type pwe3trace
local-pw-id 1
vc-type bgp
nqa status : normal
nqa test-instance a b
test-type icmpjitter
destination-address ipv4 100.1.1.201
source-address ipv4 100.1.1.200
hardware-based enable
ttl 100
tos 100
timeout 20
nqa status : normal
6.24 Configuring Round-Trip Delay Thresholds
This section describes how to set a round-trip delay transmission threshold in an NQA test
instance.
6.24.1 Establishing the Configuration Task
Before setting a round-trip transmission delay threshold, familiarize yourself with the applicable
environment, complete the pre-configuration tasks, and obtain the required data. This can help
you complete the configuration task quickly and accurately.
Applicable Environment
If the round-trip transmission delay threshold is configured for a NQA test instance, the NQA
test result will contain the statistics on the test packets that exceed the set threshold. This provides
the basis for the network manager to analyze the operation status of the specified service.
Pre-configuration Tasks
Before configuring the round-trip transmission delay threshold, complete the following tasks:
l Running the device normally
l Creating NQA test instances and configuring related parameters correctly
Data Preparation
To configure the round-trip transmission delay threshold, you need the following data.
Quidway S5700 Series Ethernet Switches
Configuration Guide - Network Management 6 NQA Configuration
Issue 01 (2011-10-26) Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
325
To Next Page
Loading...
Need help?
General
