Huawei Quidway S5700 Series - Example for Configuring the Test of Sending NQA Threshold Traps to the NMS

area 0.0.0.0
network 5.5.5.9 0.0.0.0
network 40.1.1.0 0.0.0.255
#
return
l Configuration file of CE-B
#
sysname CE-B
#
vlan batch 160
#
interface Vlanif160
ip address 100.1.1.2 255.255.255.0
#
interface GigabitEthernet0/0/1
port hybrid pvid vlan 160
port hybrid untagged vlan 160
#
return
6.27.18 Example for Configuring the Test of Sending NQA
Threshold Traps to the NMS
Networking Requirements
As shown in Figure 6-20, the trap threshold are configured and the function of sending trap
messages is enabled when a Jitter test is configured. After the Jitter test is complete, Switch A
sends a trap message to the NMS when the interval for transmitting the test packet from
Switch A to Switch C or from Switch C to Switch A exceeds the configured unidirectional
transmission threshold, or when the RTT of the test packet exceeds the configured bidirectional
transmission threshold. Network administrators can view the cause of a trap in the trap message
received by the NMS.
Figure 6-20 Network diagram for configuring the NQA threshold
NQA Server
NM Station
GE0/0/1
VLANIF120
10.1.1.1/24
GE0/0/1
VLANIF120
10.1.1.2/24
GE0/0/1
VLANIF130
30.1.1.2/24
GE0/0/2
VLANIF130
30.1.1.1/24
GE0/0/2
20.1.1.2/24
SwitchA
SwitchB
SwitchC
VLANIF110
20.1.1.1/24
NOTE
For the information about clock synchronization, see "NTP" in the Quidway S5700 Series Ethernet
Switches Feature Description - Network Management.
Configuration Roadmap
The configuration roadmap is as follows:
Quidway S5700 Series Ethernet Switches
Configuration Guide - Network Management 6 NQA Configuration
Issue 01 (2011-10-26) Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
385