CtrlConnTime Min/Max/Average: 438/438/438
DataConnTime Min/Max/Average: 218/218/218
SumTime Min/Max/Average: 656/656/656
Average RTT:380
Lost packet ratio: 0 %
6.8 Configuring the HTTP Test
This section describes how to configure a Hypertext Transfer Protocol (HTTP) test to check the
responding speed of the HTTP service in each phase.
6.8.1 Establishing the Configuration Task
Before configuring an HTTP test, familiarize yourself with the applicable environment,
complete the pre-configuration tasks, and obtain the required data. This can help you complete
the configuration task quickly and accurately.
Applicable Environment
Through the NQA HTTP test, you can obtain the responding speed in three phases:
l Time of DNS resolution: It is a period from the time the client sends the DNS packet to the
resolver for resolving the name of the HTTP server to an IP address to the time the DNS
resolution packets containing the IP address is returned.
l Time to set up a TCP connection: It is the time taken by the client to set up a TCP connection
with an HTTP server through three-way handshake.
l Transaction time: It is a period from the time the client sends the Get or Post packets to an
HTTP server to the time the Echo packet sent by the client reaches the HTTP server.
Pre-configuration Tasks
Before configuring the HTTP test, complete the following tasks:
l Configuring the HTTP server
l Configuring routes between the NQA client and the HTTP server
Data Preparation
To configure the HTTP test, you need the following data.
No.
Data
1 Administrator name and test name
2 Name of the HTTP server
3
l (Optional) Source address, Source port number
l (Optional) Destination port number
l (Optional) Fail percent
4 HTTP operation type
5 Web page to be visited and the HTTP version
Quidway S5700 Series Ethernet Switches
Configuration Guide - Network Management 6 NQA Configuration
Issue 01 (2011-10-26) Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
269
To Next Page
Loading...
Need help?
General
