Huawei Quidway S5700 Series User Manual

No. Data
3 Host name to be resolved
4 Start mode and end mode of the test
6.9.2 Configuring the DNS Test Parameters
This part describes how to set DNS test parameters.
Context
Do as follows on the NQA client (DNS client):
Procedure
Step 1 Run
system-view
The system view is displayed.
Step 2 Run:
dns resolve
Enable dynamic DNS resolution. By default, the function is disabled.
Step 3 Run:
nqa test-instance admin-name test-name
An NQA test instance is created and the test instance view is displayed.
Step 4 Run:
test-type dns
The test type is set to DNS.
Step 5 Run:
dns-server ipv4 ip-address
The IPv4 address of the DNS server is configured.
Step 6 Run:
destination-address url urlstring
The name of the destination host is configured.
NOTE
For detailed parameter configurations, see the chapter Configuring Universal NQA Test Parameters
Step 7 Run:
start
The NQA test is started.
Select the start mode as required because the start command has several forms.
Quidway S5700 Series Ethernet Switches
Configuration Guide - Network Management 6 NQA Configuration
Issue 01 (2011-10-26) Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
273

Huawei Quidway S5700 Series Specifications

General

Category	Switch
Operating Temperature	0°C to 45°C
Relative Humidity	5% to 95% (non-condensing)
Series	Quidway S5700
Forwarding Performance	Up to 96 Mpps
Ports	24 or 48 x 10/100/1000Base-T ports
Power Supply	AC or DC
Storage Temperature	-40°C to 70°C
Fixed GE Ports	24 or 48
Uplink Ports	4 x GE SFP ports
Routing Protocols	RIP, OSPF, BGP
Management	SNMP, RMON, CLI, Web
VLAN	4094 VLANs
PoE	Optional