#
cluster enable
ntdp enable
ntdp hop 3
ntdp timer 10
ndp enable
#
interface Vlanif10
#
interface GigabitEthernet0/0/1
port link-type trunk
port trunk allow-pass vlan 10
ntdp enable
ndp enable
#
cluster
mngvlanid 10
administrator-address 0001-0001-0001 name HUAWEI
#
return
3.6.8 Example for Configuring the Incremental Configuration
Function for an HGMP Cluster
Networking Requirements
As shown in Figure 3-10, all the Layer 2 switches belong to the same cluster. Administrator-1
is the administrator switch of the cluster and other switches are member switches. The member
ID of Member-2 is 2 and the member ID of Member-3 is 3.
To configure VLAN 100 to VLAN 200 on Member-2 and Member-3 and a static route with its
next hop address being the administrator switch, you can use the incremental configuration
function of the HGMP cluster.
Quidway S5700 Series Ethernet Switches
Configuration Guide - Network Management 3 HGMP Configuration
Issue 01 (2011-10-26) Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
178
To Next Page
Loading...
