Huawei Quidway S5700 Series - Configuring Parameters for the PWE3 Ping Test on a One-Hop PW

No. Data
4 Destination IP address and ID of the L2VC
5 (Optional) Response mode of the Echo-Request packets, LSP EXP, maximum hops,
number of probes, TTL value, and timeout period of the packets
6 Start mode and end mode of the test
6.19.2 Configuring Parameters for the PWE3 Ping Test on a One-
Hop PW
This part describes how to set PWE3 ping test parameters for a single-hop PW.
Context
Do as follows on the NQA client:
Procedure
Step 1 Run:
system-view
The system view is displayed.
Step 2 Run:
nqa test-instance admin-name test-name
An NQA test instance is created and the test instance view is displayed.
Step 3 Run:
test-type pwe3ping
The test type is set to PWE3 Ping.
Step 4 (Optional) Run:
vc-type ldp
The method of setting up a PW is configured.
Step 5 (Optional) Run:
local-pw-type { local-pw-type | ip-interworking }
The type of the local PW is configured. By default, the type is Ethernet.
Step 6 (Optional) Run:
label-type { control-word | label-alert | normal }
The type of the PW label is configured.
Step 7 Run:
local-pw-id local-pw-id
The ID of the local end of the PW is configured.
Quidway S5700 Series Ethernet Switches
Configuration Guide - Network Management 6 NQA Configuration
Issue 01 (2011-10-26) Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
307