3.5 Maintaining HGMP
This section describes how to clear the statistics on NDP, and monitor the operation status of
the HGMP cluster.
3.5.1 Clearing the NDP Statistics
This part describes how to use the reset ndp statistics command to clear the statistics on NDP.
Context
CAUTION
Once statistics are cleared, they cannot be restored. Confirm the action before you use the
command.
Procedure
Step 1 Run the reset ndp statistics [ interface { interface-type interface-number [ to interface-type
interface-number ] } &<1-10> ] command in the user view to clear the NDP statistics.
----End
3.5.2 Monitoring the Operation Status of the HGMP Cluster
This part describes how to use the display commands to monitor the operating status of the
HGMP cluster.
Context
In routine maintenance, you can run the following commands in any view to display the operation
stauts of HGMP.
Procedure
l Run the display ndp to check the NDP configuration in the system view.
l Run the display ntdp to check the global NTDP configuration.
l Run the display cluster to check information about the HGMP cluster to which the device
belongs.
l Run the display ntdp device-list [ verbose ] to check information about the HGMP cluster
to which the device belongs.
l Run the display cluster-topology-info to check the cluster topology information.
l Run the display cluster candidates [ mac-address mac-address | verbose ] to check
information about candidate switches.
----End
Quidway S5700 Series Ethernet Switches
Configuration Guide - Network Management 3 HGMP Configuration
Issue 01 (2011-10-26) Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
108
To Next Page
Loading...
Need help?
General
