The cluster view is displayed.
3. Run:
auto-build [ recover ]
A member switch is added automatically.
The auto-build command can also be used to create a cluster automatically. For
configuration details, see Creating a Cluster.
recover indicates that all member switches, including the member switches missing
on the administrator switch should re-join the HGMP cluster.
NOTE
If the administrator switch of HGMP cluster A considers that switch N does not belong to
cluster A but switch N considers that it belongs to cluster A, switch N is called the missing
member switch on the administrator switch.
----End
3.3.6 (Optional) Deleting or Quitting a Cluster
Context
If you do not need to use a cluster to manage a switch, you can delete the switch or configure
the switch to quit the cluster.
Procedure
l Deleting a cluster
Do as follows on the administrator switch:
1. Run:
system-view
The system view is displayed.
2. Run
cluster
The cluster view is displayed.
3. Run:
undo build
A cluster is deleted.
After the command is run on an administrator switch, except the mngvlanid and ip-
pool commands, configurations of the administrator switch in the HGMP cluster view
are deleted; all member switches automatically quit the cluster.
l Disabling a cluster
Do as follows on the administrator switch or a member switch:
1. Run:
system-view
The system view is displayed.
Quidway S5700 Series Ethernet Switches
Configuration Guide - Network Management 3 HGMP Configuration
Issue 01 (2011-10-26) Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
93
To Next Page
Loading...
Need help?
General
