Huawei Quidway S5700 Series - Sending Trap Messages When Probes Are Complete

NOTE
Only S5700HI and S5706 support ICMP Jitter.
Step 4 Run:
destination-address ipv4 ip-address
The destination IP address is configured.
Step 5 (Optional)Run:
destination-port port-number
The destination port number is configured.
Step 6 Run:
send-trap probefailure
Sending trap messages when probes fail is enabled.
By default, the trap function is disabled.
Step 7 Run:
probe-failtimes times
The number probe failures that trigger sending a Trap message is configured.
By default, a trap message is sent for each probe failure.
----End
6.25.4 Sending Trap Messages When Probes Are Complete
A trap message is sent to the NMS when the NQA test is complete.
Context
Do as follows on the NQA client:
Procedure
Step 1 Run:
system-view
The system view is displayed.
Step 2 Run:
nqa test-instance admin-name test-name
An NQA test instance is created and the test instance view is displayed.
Step 3 Run:
test-type { jitter | icmpjitter }
The test type is configured.
NOTE
Only S5700HI and S5706 support ICMP Jitter.
Step 4 Run:
destination-address ipv4 ip-address
Quidway S5700 Series Ethernet Switches
Configuration Guide - Network Management 6 NQA Configuration
Issue 01 (2011-10-26) Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
330