Huawei Quidway S5700 Series - Example for Configuring an ICMP Jitter Test

area 0.0.0.0
network 2.2.2.9 0.0.0.0
network 10.1.1.0 0.0.0.255
network 10.2.1.0 0.0.0.255
#
return
l Configuration file of Switch C
#
sysname SwitchC
#
vlan batch 100
#
mpls lsr-id 1.1.1.9
mpls
#
mpls ldp
#
interface Vlanif110
ip address 10.2.1.2 255.255.255.0
mpls
mpls ldp
#
interface GigabitEthernet0/0/1
port hybrid pvid vlan 110
port hybrid untagged vlan 110
#
interface LoopBack1
ip address 3.3.3.9 255.255.255.255
#
ospf 1
area 0.0.0.0
network 3.3.3.9 0.0.0.0
network 10.2.1.0 0.0.0.255
#
return
6.27.13 Example for Configuring an ICMP Jitter Test
This part provides examples for configuring an ICMP jitter test to measure jitter on the network.
A server is not required in an ICMP jitter test and the peer device in the test instance can be non-
Huawei devices.
Networking Requirements
As shown in Figure 6-15,
Switch A serves as the NQA client to test the jitter of the network between Switch A and Switch
B.
Figure 6-15 Networking diagram of an ICMP jitter test
SwitchA
GE0/0/1
GE0/0/1
SwitchB
VLANIF10
10.1.1.1/24
VLANIF10
10.1.1.2/24
Configuration Roadmap
The configuration roadmap is as follows:
Quidway S5700 Series Ethernet Switches
Configuration Guide - Network Management 6 NQA Configuration
Issue 01 (2011-10-26) Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
362