EasyManuals Logo

Huawei Quidway S5700 Series User Manual

Huawei Quidway S5700 Series
415 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #267 background imageLoading...
Page #267 background image
6.1 Introduction to NQA
This section helps you understand the background and functions of Network Quality Analysis
(NQA).
As the value-added services on networks are developed, users and carriers demand higher
Quality of Service (QoS). To ensure users with the committed bandwidth, network operators
should collect the statistics of latency, jitter, and packet loss of the device. This helps them
analyze network performance in time.
NQA on the S5700 meets the preceding requirements.
NQA measures the performance of each protocol running on the network and helps network
operators collect network operation statistics, such as the total HTTP delay, TCP connection
delay, file transfer rate, FTP connection delay, Domain Name System (DNS) resolution delay,
and DNS resolution error ratio. By collecting these statistics, network operators provide users
with network services of various grades.
NQA is an efficient tool for diagnosing and locating faults on a network.
6.2 Comparisons Between NQA and Ping
This part describes the differences between NQA and Ping tests.
NQA is the extension and enhancement of Ping.
By sending an Internet Control Message Protocol (ICMP) Echo-Request packet from the local
and expecting an ICMP Echo-Reply packet from the specified destination, the Ping program can
test the round-trip time (RTT) of an ICMP packet. In addition to testing the RRT of an ICMP
packet between the local and the desination, NQA can detect whether network services, such as
TCP, UDP, FTP, HTTP and the Simple Network Management Protocol (SNMP), are enabled
and test the response time of each service.
Figure 6-1 Diagram of the NQA test
NQA Client
IP/MPLS
Network
Server
In NQA, the RTT of each packet or timeout period of the packet is not displayed on the terminal
in real time, unlike the Ping program. Test results are displayed only when you run the display
nqa results command after a test is complete.
You can also configure the Network Management System (NM Station) to control each NQA
operation parameter and enable NQA tests.
Quidway S5700 Series Ethernet Switches
Configuration Guide - Network Management 6 NQA Configuration
Issue 01 (2011-10-26) Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
256

Table of Contents

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Huawei Quidway S5700 Series and is the answer not in the manual?

Huawei Quidway S5700 Series Specifications

General IconGeneral
CategorySwitch
Operating Temperature0°C to 45°C
Relative Humidity5% to 95% (non-condensing)
SeriesQuidway S5700
Forwarding PerformanceUp to 96 Mpps
Ports24 or 48 x 10/100/1000Base-T ports
Power SupplyAC or DC
Storage Temperature-40°C to 70°C
Fixed GE Ports24 or 48
Uplink Ports4 x GE SFP ports
Routing ProtocolsRIP, OSPF, BGP
ManagementSNMP, RMON, CLI, Web
VLAN4094 VLANs
PoEOptional

Related product manuals