EasyManuals Logo

Huawei Quidway S5700 Series User Manual

Huawei Quidway S5700 Series
415 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #228 background imageLoading...
Page #228 background image
Step 2 is optional. If source-interface is specified in both Step 2 and Step 3, use the
source interface specified in Step 3 preferentially.
ip-address is the IP address of the NTP peer. It can be the IP address of a host address
rather than a broadcast address, a multicast address, or the IP address of the reference
clock.
NOTE
After the NTP peer is specified, the local switch runs in symmetric active mode. The symmetric
passive end need not be configured.
l (Optional) Configuring the Source Interface of the NTP Symmetric Passive End
1. Run:
system-view
The system view is displayed.
2. Run:
ntp-service source-interface vlanif vlan-id
The local source interface that sends NTP packets is specified.
Commonly, specify the IP address of the NTP server on the client. The client and
server can then exchange NTP packets using this IP address
If the source interface to send NTP packets is specified on the symmetric active end,
the IP address of the NTP peer configured on the symmetric passive end should be
the same; otherwise, the passive end cannot process NTP packets sent from the active
end and clock synchronization fails.
----End
4.3.5 Configuring the Broadcast Mode
This part describes how to configure the NTP broadcast mode on the LAN to synchronize clocks
on the LAN.
Procedure
l Configuring an NTP Broadcast Server
Do as follows on the switch functioning as an NTP broadcast server:
1. Run:
system-view
The system view is displayed.
2. Run:
vlan vlan-id
A VLAN is created and the VLAN view is displayed.
3. Run:
interface vlanif vlan-id
The interface that sends NTP broadcast packets is specified.
4. Run:
ntp-service broadcast-server [ authentication-keyid key-id | version
number ]*
Quidway S5700 Series Ethernet Switches
Configuration Guide - Network Management 4 NTP Configuration
Issue 01 (2011-10-26) Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
217

Table of Contents

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Huawei Quidway S5700 Series and is the answer not in the manual?

Huawei Quidway S5700 Series Specifications

General IconGeneral
CategorySwitch
Operating Temperature0°C to 45°C
Relative Humidity5% to 95% (non-condensing)
SeriesQuidway S5700
Forwarding PerformanceUp to 96 Mpps
Ports24 or 48 x 10/100/1000Base-T ports
Power SupplyAC or DC
Storage Temperature-40°C to 70°C
Fixed GE Ports24 or 48
Uplink Ports4 x GE SFP ports
Routing ProtocolsRIP, OSPF, BGP
ManagementSNMP, RMON, CLI, Web
VLAN4094 VLANs
PoEOptional

Related product manuals