Huawei Quidway S5700 Series User Manual

6.11.1 Establishing the Configuration Task
Before configuring an SNMP query test, familiarize yourself with the applicable environment,
complete the pre-configuration tasks, and obtain the required data. This can help you complete
the configuration task quickly and accurately.
Applicable Environment
Through the SNMP Query test, you can obtain the statistics of the communication between hosts
and SNMP agents.
Pre-configuration Tasks
Before configuring the SNMP Query test, complete the following tasks:
l Configuring the SNMP agent
l Configuring routes between the NQA client and the SNMP agent
Data Preparation
To configure the SNMP query test, you need the following data.
No.
Data
1 Administrator name and test name
2 IP address of the SNMP agent
3 (Optional) Source IP addresses and source port numbers of test packets, interval for
sending test packets, and percentage of the failed NQA tests
4 Start mode and end mode of the test
6.11.2 Configuring the SNMP Query Test Parameters
This part describes how to set SNMP query test parameters.
Context
Do as follows on the NQA client:
Procedure
Step 1 Run:
system-view
The system view is displayed.
Step 2 Run:
nqa test-instance admin-name test-name
An NQA test instance is created and the test instance view is displayed.
Quidway S5700 Series Ethernet Switches
Configuration Guide - Network Management 6 NQA Configuration
Issue 01 (2011-10-26) Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
278

Huawei Quidway S5700 Series Specifications

General

Category	Switch
Operating Temperature	0°C to 45°C
Relative Humidity	5% to 95% (non-condensing)
Series	Quidway S5700
Forwarding Performance	Up to 96 Mpps
Ports	24 or 48 x 10/100/1000Base-T ports
Power Supply	AC or DC
Storage Temperature	-40°C to 70°C
Fixed GE Ports	24 or 48
Uplink Ports	4 x GE SFP ports
Routing Protocols	RIP, OSPF, BGP
Management	SNMP, RMON, CLI, Web
VLAN	4094 VLANs
PoE	Optional