Huawei Quidway S5700 Series User Manual

Step 3 Run:
test-type snmp
The test type is set to SNMP Query.
Step 4 Run:
destination-address ipv4 ip-address
The destination IP address, that is, the IP address of the SNMP agent, is configured.
NOTE
The SNMP function must be enabled on the destination host; otherwise, the destination host fails to receive
Echo packets.
Step 5 (Optional) Perform the following as required to configure other parameters for the SNMP test
( For detailed parameter configurations, see the chapter Configuring Universal NQA Test
Parameters ):
l To configure the VPN instance to be tested, run the vpn-instance vpn-instance-name
command.
NOTE
Only S5700EI and S5700HI support the vpn-instance command.
l To configure the source IP address, run the source-address ipv4 ip-address command.
l To configure the source port number, run the source-port port-numbercommand.
l To configure the interval for sending test packets, run the interval seconds interval
command.
l To configure the percentage of the failed NQA tests, run the fail-percent percent command.
l To configure the NQA test packets to be sent without searching the routing table, run the
sendpacket passroute command.
Step 6 Run:
start
The NQA test is started.
Select the start mode as required because the start command has several forms.
l To perform the NQA test immediately, run the start now [ end { at [ yyyy/mm/dd ]
hh:mm:ss | delay { seconds second | hh:mm:ss } | lifetime { seconds second | hh:mm:ss } } ]
command.
The test instance is started immediately.
l To perform the NQA test at the specified time, run the start at [ yyyy/mm/dd ] hh:mm:ss
[ end { at [ yyyy/mm/dd ] hh:mm:ss | delay { seconds second | hh:mm:ss } | lifetime
{ seconds second | hh:mm:ss } } ] command.
The test instance is started at a specified time.
l To perform the NQA test after a certain delay period, run the start delay { seconds second
| hh:mm:ss } [ end { at [ yyyy/mm/dd ] hh:mm:ss | delay { seconds second | hh:mm:ss } |
lifetime { seconds second | hh:mm:ss } } ] command.
The test instance is started after a certain delay.
----End
Quidway S5700 Series Ethernet Switches
Configuration Guide - Network Management 6 NQA Configuration
Issue 01 (2011-10-26) Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
279

Huawei Quidway S5700 Series Specifications

General

Category	Switch
Operating Temperature	0°C to 45°C
Relative Humidity	5% to 95% (non-condensing)
Series	Quidway S5700
Forwarding Performance	Up to 96 Mpps
Ports	24 or 48 x 10/100/1000Base-T ports
Power Supply	AC or DC
Storage Temperature	-40°C to 70°C
Fixed GE Ports	24 or 48
Uplink Ports	4 x GE SFP ports
Routing Protocols	RIP, OSPF, BGP
Management	SNMP, RMON, CLI, Web
VLAN	4094 VLANs
PoE	Optional