The test instance is started after a certain delay.
----End
6.10.3 Checking the Configuration
After configuring a traceroute test, you can view the test result.
Prerequisite
The configurations of the traceroute test are complete.
Context
NOTE
NQA test results cannot be displayed automatically on the terminal. You need to run the display nqa
results command to view test results. By the default, the command output contains the records about only
the last five tests.
Procedure
Step 1 Run the display nqa results [ test-instance admin-name test-name ] command to view the test
results on the NQA client.
----End
Example
Run the display nqa results command. If the statistics about each hop are displayed, it means
that the traceroute test is successful.
<Quidway> display nqa results
NQA entry(t, t) :testflag is inactive ,testtype is trace
1 . Test 1 result The test is finished
Completion:success Attempts number:1
Disconnect operation number:0 Operation timeout number:0
System busy operation number:0 Connection fail number:0
Operation sequence errors number:0 RTT Stats errors number:0
Drop operation number:0
Last good path Time:2010-06-21 15:41:01.7
1 . Hop 1
Send operation times: 3 Receive response times: 3
Min/Max/Average Completion Time: 1/2/1
Sum/Square-Sum Completion Time: 4/6
RTD OverThresholds number: 0
Last Good Probe Time: 2010-06-21 15:41:01.7
Destination ip address:10.112.58.3
Lost packet ratio: 0 %
6.11 Configuring the SNMP Query Test
This section describes how to configure a Simple Network Management Protocol (SNMP) query
test to check the communications between the host and SNMP agent.
Quidway S5700 Series Ethernet Switches
Configuration Guide - Network Management 6 NQA Configuration
Issue 01 (2011-10-26) Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
277
To Next Page
Loading...
Need help?
General
