Huawei Quidway S5700 Series - 6.14 Configuring the Jitter Test

The system view is displayed.
Step 2 Run:
nqa test-instance admin-name test-name
An NQA test instance is created and the test instance view is displayed.
Step 3 Run:
test-type trace
A traceroute test is created.
Step 4 Run:
destination-address ipv4 ip-address
The destination address of the traceroute test is configured.
Step 5 Run the following commands as required ( For detailed parameter configurations, see the chapter
Configuring Universal NQA Test Parameters ):
l To configure the VPN instance to be tested, run the vpn-instance vpn-instance-name
command.
NOTE
Only S5700EI and S5700HI support the vpn-instance command.
l To configure the maximum hops, run:
tracert-hopfailtimes times
l To configure the initial TTL and maximum TTL values of a packet, run:
tracert-livetime first-ttl first-ttl max-ttl max-ttl
l To configure the source IP address, run:
source-address ipv4 ip-address
l To configure the destination port number, run:
destination-port port-number
l To configure a NQA test packets to be sent without searching the routing table, run:
sendpacket passroute
Step 6 Run:
start
An NQA test is started.
Select the start mode as required because the start command has several forms.
l To start the NQA test immediately, run the start now [ end { at [ yyyy/mm/dd ] hh:mm:ss |
delay { seconds second | hh:mm:ss } | lifetime { seconds second | hh:mm:ss } } ] command.
The test instance is started immediately.
l To start the NQA test at the specified time, run the start at [ yyyy/mm/dd ] hh:mm:ss [ end
{ at [ yyyy/mm/dd ] hh:mm:ss | delay { seconds second | hh:mm:ss } | lifetime { seconds
second | hh:mm:ss } } ] command.
The test instance is started at a specified time.
l To start the NQA test after a certain delay, run the start delay { seconds second |
hh:mm:ss } [ end { at [ yyyy/mm/dd ] hh:mm:ss | delay { seconds second | hh:mm:ss } |
lifetime { seconds second | hh:mm:ss } } ] command.
Quidway S5700 Series Ethernet Switches
Configuration Guide - Network Management 6 NQA Configuration
Issue 01 (2011-10-26) Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
276