Pre-configuration Tasks
Before configuring RMON, complete the following tasks:
l Configuring parameters for Ethernet interfaces
l Configuring basic SNMP functions
Data Preparation
To configure RMON, you need the following data.
No. Data
1 Interface on which the statistics function is enabled
2 Statistics table to be used and related parameters
3 HistoryControl table to be used and related parameters
4 Event table to be used and related parameters
5 Alarm table to be used and related parameters
6 Prialarm table to be used and related parameters
7.3.2 Enabling the RMON Statistics Function on the Interface
You need to enable traffic statistics function on the interface where traffic statistics are collected.
If the traffic statistics function is not enabled on the interface, statistics values of in both
ethernetStatsTable and HistoryControlTable are 0.
Context
Do as follows on the switch on which traffic statistics should be collected:
Procedure
Step 1 Run:
system-view
The system view is displayed.
Step 2 Run:
interface { gigabitethernet | xgigabitethernet } interface-number
The interface view is displayed.
Step 3 Run:
rmon-statistics enable
The RMON statistics function is enabled on the interface.
If the statistics function is not enabled on the interface, the statistics value in ethernetStatsTable
and historyControlTable of RMON is 0.
----End
Quidway S5700 Series Ethernet Switches
Configuration Guide - Network Management 7 RMON Configuration
Issue 01 (2011-10-26) Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
394
To Next Page
Loading...
Need help?
General
