EasyManua.ls Logo

Huawei Quidway S5700 Series - Configuring the PWE3 Ping Test to Check the One-Hop PW; Establishing the Configuration Task

Huawei Quidway S5700 Series
415 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
System busy operation number:0 Operation timeout number:0
Min Positive SD:1 Min Positive DS:1
Max Positive SD:138 Max Positive DS:3
Positive SD Number:7 Positive DS Number:19
Positive SD Sum:152 Positive DS Sum:21
Positive SD Square Sum :19116 Positive DS Square Sum :27
Min Negative SD:1 Min Negative DS:1
Max Negative SD:21 Max Negative DS:4
Negative SD Number:14 Negative DS Number:19
Negative SD Sum:152 Negative DS Sum:22
Negative SD Square Sum :2796 Negative DS Square Sum :34
Min Delay SD:1 Min Delay DS:0
Max Delay SD:72 Max Delay DS:71
Delay SD Square Sum:15111 Delay DS Square Sum:14728
Packet Loss SD:0 Packet Loss DS:0
Packet Loss Unknown:0 Average of Jitter:5
Average of Jitter SD:14 Average of Jitter DS:1
jitter out value:4.7604818 jitter in value:0.5399519
NumberOfOWD:60 Packet Loss Ratio: 0%
OWD SD Sum:339 OWD DS Sum:310
ICPIF value: 0 MOS-CQ value: 0
TimeStamp unit: ms
6.19 Configuring the PWE3 Ping Test to Check the One-Hop
PW
This section describes how to configure a PWE3 ping test to check the connectivity of a single-
hop pseudo-wire (PW).
6.19.1 Establishing the Configuration Task
Before configuring a PWE3 ping test for a single-hop PW, familiarize yourself with the
applicable environment, complete the pre-configuration tasks, and obtain the required data. This
can help you complete the configuration task quickly and accurately.
Applicable Environment
To check the connectivity of the one-hop pseudo wire (PW) using LDP as the signaling protocol,
you can perform the PWE3 Ping test on the one-hop PW.
Pre-configuration Tasks
Before configuring the PWE3 Ping test on a one-hop PW, you must correctly configure the
dynamic one-hop PW.
Data Preparation
To configure the PWE3 Ping test on a one-hop PW, you need the following data.
No.
Data
1 ID of the PW
2 Type of the PW
3 Type and number of the interface connected with the CE
Quidway S5700 Series Ethernet Switches
Configuration Guide - Network Management 6 NQA Configuration
Issue 01 (2011-10-26) Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
306

Table of Contents

Related product manuals