Huawei Quidway S5700 Series - Example for Configuring the PWE3 Trace Test on a Single-Hop PW

#
interface Vlanif150
ip address 40.1.1.2 255.255.255.0
mpls
mpls ldp
#
interface Vlanif160
mpls l2vc 3.3.3.9 200
#
interface GigabitEthernet0/0/1
port hybrid pvid vlan 150
port hybrid untagged vlan 150
#
interface GigabitEthernet0/0/2
port hybrid pvid vlan 160
port hybrid untagged vlan 150
#
#
interface LoopBack0
ip address 5.5.5.9 255.255.255.255
#
ospf 1
area 0.0.0.0
network 5.5.5.9 0.0.0.0
network 40.1.1.0 0.0.0.255
#
return
l Configuration file of CE-B
#
sysname CE-B
#
vlan batch 160
#
interface Vlanif160
ip address 100.1.1.2 255.255.255.0
#
interface GigabitEthernet0/0/1
port hybrid pvid vlan 160
port hybrid untagged vlan 160
#
return
6.27.16 Example for Configuring the PWE3 Trace Test on a Single-
Hop PW
Networking Requirements
As shown in Figure 6-18, CE-A and CE-B are respectively connected to PE-A and PE-B through
VLAN. PE-A and PE-B are connected through the MPLS backbone network. A dynamic PW
needs to be set up between PE-A and PE-B through the LSP tunnel.
The PWE3 Trace function of the single-hop PW needs to be performed to test the connectivity
of the PW between PE-A and PE-B.
Quidway S5700 Series Ethernet Switches
Configuration Guide - Network Management 6 NQA Configuration
Issue 01 (2011-10-26) Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
374