Huawei Quidway S5700 Series User Manual

5 Ping and Tracert
About This Chapter
This chapter describes basic concepts and applications of the ping and tracert commands.
5.1 Ping
The ping command is used to check network connectivity and host reachability. The word "ping"
is derived from the sonar operation, indicating a pulse of sound.
5.2 Tracert
Tracert, also called Trace Route, is used to check the IP addresses and the number of gateways
between the source and the destination. Tracert is helpful in testing network reachability and
locating the fault on the network.
5.3 Performing Ping and Tracert Operations
This section describes the execution of the ping and tracert commands.
5.4 Debugging Ping and Tracert
This section describes how to locate faults through ICMP messages.
5.5 Configuration Examples
This section provides a configuration example of ping and tracert operations.
Quidway S5700 Series Ethernet Switches
Configuration Guide - Network Management 5 Ping and Tracert
Issue 01 (2011-10-26) Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
245

Huawei Quidway S5700 Series Specifications

General

Category	Switch
Operating Temperature	0°C to 45°C
Relative Humidity	5% to 95% (non-condensing)
Series	Quidway S5700
Forwarding Performance	Up to 96 Mpps
Ports	24 or 48 x 10/100/1000Base-T ports
Power Supply	AC or DC
Storage Temperature	-40°C to 70°C
Fixed GE Ports	24 or 48
Uplink Ports	4 x GE SFP ports
Routing Protocols	RIP, OSPF, BGP
Management	SNMP, RMON, CLI, Web
VLAN	4094 VLANs
PoE	Optional