6 NQA Configuration
About This Chapter
This chapter describes how to configure the Network Quality Analysis (NQA) to monitor the
network operating status and collect network operation indexes in real time.
6.1 Introduction to NQA
This section helps you understand the background and functions of Network Quality Analysis
(NQA).
6.2 Comparisons Between NQA and Ping
This part describes the differences between NQA and Ping tests.
6.3 NQA Server and NQA Clients
This part describes the relationships between NQA client, NQA server, and NQA test instance.
6.4 NQA Supported by the S5700
This part describes NQA test types and scheduling modes supported by the S5700.
6.5 Configuring the ICMP Test
This section describes how to configure an Internet Control Message Protocol (ICMP) test to
check the IP network connectivity.
6.6 Configuring the FTP Download Test
This section describes how to configure a File Transfer Protocol (FTP) download test to check
the FTP download performance.
6.7 Configuring the FTP Upload Test
This section describes how to configure an FTP upload test to check the FTP upload performance.
6.8 Configuring the HTTP Test
This section describes how to configure a Hypertext Transfer Protocol (HTTP) test to check the
responding speed of the HTTP service in each phase.
6.9 Configuring the DNS Test
This section describes how to configure a Domain Name System (DNS) test to check the DNS
resolution speed.
6.10 Configuring the Traceroute Test
Quidway S5700 Series Ethernet Switches
Configuration Guide - Network Management 6 NQA Configuration
Issue 01 (2011-10-26) Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
253
To Next Page
Loading...
Need help?
General
