This section describes how to configure a traceroute test to check the connectivity to each hop
on the network.
6.11 Configuring the SNMP Query Test
This section describes how to configure a Simple Network Management Protocol (SNMP) query
test to check the communications between the host and SNMP agent.
6.12 Configuring the TCP Test
This section describes how to configure a Transmission Control Protocol (TCP) test to check
the responding speed of a TCP port.
6.13 Configuring the UDP Test
This section describes how to configure a User Datagram Protocol (UDP) test to check the
responding speed of a UDP port.
6.14 Configuring the Jitter Test
This section describes how to configure a jitter test to check jitter on the network. You can
perform a jitter test only when both the client and the server are Huawei devices.
6.15 Configuring the LSP Ping Test
This section describes how to configure a Label Switched Path (LSP) ping test to check the
operating status of the LSP.
6.16 Configuring the LSP Jitter Test
This section describes how to configure an LSP jitter test to measure jitter in the LSP during the
packet transmission.
6.17 Configuring the LSP Trace Test
This section describes how to configure an LSP trace test to check the connectivity between
Label Switching Routers (LSRs) along the LSP.
6.18 Configuring an ICMP Jitter Test
This section describes how to configure an ICMP jitter test to measure jitter on IP networks.
6.19 Configuring the PWE3 Ping Test to Check the One-Hop PW
This section describes how to configure a PWE3 ping test to check the connectivity of a single-
hop pseudo-wire (PW).
6.20 Configuring the PWE3 Ping Test to Check the Multi-Hop PW
This section describes how to configure a PWE3 ping test to check the connectivity of a multi-
hop PW.
6.21 Configuring the PWE3 Trace Test to Check the One-Hop PW
This section describes how to configure a PWE3 trace test to check the communications between
devices along a PW.
6.22 Configuring the PWE3 Trace Test to Check the Multi-Hop PW
This section describes how to configure a PWE3 trace test to check the communications between
devices on a PW.
6.23 Configuring Universal NQA Test Parameters
This section describes how to set and use universal parameters for NQA test instances.
6.24 Configuring Round-Trip Delay Thresholds
This section describes how to set a round-trip delay transmission threshold in an NQA test
instance.
6.25 Configuring the Trap Function
Quidway S5700 Series Ethernet Switches
Configuration Guide - Network Management 6 NQA Configuration
Issue 01 (2011-10-26) Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
254
To Next Page
Loading...
Need help?
General
