Huawei Quidway S5700 Series User Manual

NOTE
The private IP addresses used by a cluster cannot be the same as any IP address on the device.
4. Run:
auto-build [ recover ]
A cluster is created automatically.
The auto-build command can also be used to add member switches automatically.
For configuration details, see Adding a Member Switch.
----End
3.3.5 Adding a Member Switch
To perform unified management over a switch that is not a member of a cluster, you must first
add the switch to the cluster.
Context
After a cluster is set up, you can add a member switch to the cluster either manually or
automatically.
Procedure
l Adding a member switch manually
In this mode, you must manually specify the MAC address of the member switch.
Do as follows only on the administrator switch:
1. Run:
system-view
The system view is displayed.
2. Run:
cluster
The cluster view is displayed.
3. Run:
add-member [ member-number ] mac-address mac-address [ password password]
A member switch is added.
l Adding a member switch automatically
In this mode, the administrator switch prompts you whether to add all the existing candidate
switches to the cluster. If the authentication mode is used to add member switches, the
administrator switch quits the action of adding a member switch.
Do as follows only on the administrator switch:
1. Run:
system-view
The system view is displayed.
2. Run:
cluster
Quidway S5700 Series Ethernet Switches
Configuration Guide - Network Management 3 HGMP Configuration
Issue 01 (2011-10-26) Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
92

Huawei Quidway S5700 Series Specifications

General

Category	Switch
Operating Temperature	0°C to 45°C
Relative Humidity	5% to 95% (non-condensing)
Series	Quidway S5700
Forwarding Performance	Up to 96 Mpps
Ports	24 or 48 x 10/100/1000Base-T ports
Power Supply	AC or DC
Storage Temperature	-40°C to 70°C
Fixed GE Ports	24 or 48
Uplink Ports	4 x GE SFP ports
Routing Protocols	RIP, OSPF, BGP
Management	SNMP, RMON, CLI, Web
VLAN	4094 VLANs
PoE	Optional