Example
Run the display nqa results command. If the test is successful, the following is displayed.
l "DNSRTT"
l "TCPConnectRTT"
l "TransactionRTT and RTT"
<Quidway> display nqa results
NQA entry(admin, http) :testflag is inactive ,testtype is http
1 . Test 1 result The test is finished
SendProbe:3 ResponseProbe:3
Completion:success RTD OverThresholdsnumber: 0
MessageBodyOctetsSum: 411 TargetAddress: 100.2.1.200
DNSQueryError number: 0 HTTPError number: 0
TcpConnError number : 0 System busy operation number:0
DNSRTT Sum/Min/Max:0/0/0 TCPConnectRTT Sum/Min/Max: 6/1/4
TransactionRTT Sum/Min/Max: 3/1/1
RTT Sum/Min/Max/Avg: 7/1/5/2
DNSServerTimeout:0 TCPConnectTimeout:0 TransactionTimeout: 0
Lost packet ratio:0%
6.9 Configuring the DNS Test
This section describes how to configure a Domain Name System (DNS) test to check the DNS
resolution speed.
6.9.1 Establishing the Configuration Task
Before configuring a DNS test, familiarize yourself with the applicable environment, complete
the pre-configuration tasks, and obtain the required data. This can help you complete the
configuration task quickly and accurately.
Applicable Environment
The DNS test is performed to obtain the speed at which the specified domain name is resolved
to an IP address.
Pre-configuration Tasks
Before configuring the DNS test, complete the following tasks:
l Configuring the DNS server
l Configuring routes between the NQA client and the DNS server
Data Preparation
To configure the DNS test, you need the following data.
No.
Data
1 Administrator name and test name
2 IP address of the DNS server
Quidway S5700 Series Ethernet Switches
Configuration Guide - Network Management 6 NQA Configuration
Issue 01 (2011-10-26) Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
272