Sum/Square-Sum Completion Time: 155/8649
Last Good Probe Time: 2006-8-5 15:55:15.3
Lost packet ratio: 0 %
Run the display nqa-server command,the status of the NQA server is displayed.
<Quidway> display nqa-server
NQA Server Max: 100 NQA Server Num: 1
NQA Concurrent TCP Server : 1 NQA Concurrent UDP Server: 0
nqa-server tcpconnect 10.112.58.3 2000 ACTIVE
6.13 Configuring the UDP Test
This section describes how to configure a User Datagram Protocol (UDP) test to check the
responding speed of a UDP port.
6.13.1 Establishing the Configuration Task
Before configuring a UDP test, familiarize yourself with the applicable environment, complete
the pre-configuration tasks, and obtain the required data. This can help you complete the
configuration task quickly and accurately.
Applicable Environment
To obtain the time for the specified port to respond to a UDP connection request, you can create
a UDP test instance.
Pre-configuration Tasks
Before configuring the UDP test, configure reachable routes between the NQA client and the
UDP server.
Data Preparation
To configure the UDP test, you need the following data.
No.
Data
1 Administrator name and test name
2 IP address and port of the UDP server
3 Destination IP addresss and the port of the probe packets sent by the UDP client
4 (Optional) Source IP addresses and source port numbers of test packets, interval for
sending test packets, and percentage of the failed NQA tests
5 Start mode and end mode of the test
6.13.2 Configuring the UDP Server
The IP address and number of the port monitored by the server must be identical with those
configured on the client.
Quidway S5700 Series Ethernet Switches
Configuration Guide - Network Management 6 NQA Configuration
Issue 01 (2011-10-26) Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
284
To Next Page
Loading...
Need help?
General
