Huawei Quidway S5700 Series - Example for Configuring the PWE3 Ping Test on a Single-Hop PW

Configuration Files
l Configuration file of Switch A
#
sysname SwitchA
#
vlan batch 10
#
interface Vlanif10
ip address 10.1.1.1 255.255.255.0
#
interface GigabitEthernet0/0/1
port hybrid pvid vlan 10
port hybrid untagged vlan 10
#
nqa test-instance admin icmpjitter
test-type icmpjitter
#
return
l Configuration file of SwitchB
#
sysname SwitchB
#
vlan batch 10
#
interface Vlanif10
ip address 10.1.1.2 255.255.255.0
#
interface GigabitEthernet0/0/1
port hybrid pvid vlan 10
port hybrid untagged vlan 10
#
return
6.27.14 Example for Configuring the PWE3 Ping Test on a Single-
Hop PW
Networking Requirements
As shown in Figure 6-16, CE-A and CE-B are connected to PE-A and PE-B respectively. PE-
A and PE-B are connected through the MPLS backbone network. A dynamic PW needs to be
set up between PE-A and PE-B through the LSP tunnel.
The PWE3 Ping function of the single-hop PW needs to be performed to test the connectivity
of the PW between PE-A and PE-B.
Quidway S5700 Series Ethernet Switches
Configuration Guide - Network Management 6 NQA Configuration
Issue 01 (2011-10-26) Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
364