Huawei Quidway S5700 Series - Configuring the TCP Server; Configuring the TCP Client

Pre-configuration Tasks
Before configuring the TCP test, configure reachable routes between the NQA client and the
TCP server.
Data Preparation
To configure the TCP test, you need the following data.
No. Data
1 Administrator name and test name
2 IP address and port number monitored by the TCP server
3 (Optional) Destination port numbers of the probe packets sent by the TCP client and
source IP addresses , source port numbers of test packets, interval for sending test
packets, and percentage of the failed NQA tests
4 Start mode and end mode of the test
6.12.2 Configuring the TCP Server
The IP address and number of the port monitored by the server must be identical with those
configured on the client.
Context
Do as follows on the NQA server (TCP server):
Procedure
Step 1 Run:
system-view
The system view is displayed.
Step 2 Run:
nqa-server tcpconnect [ vpn-instance vpn-instance-name ] ip-address port-number
The TCP monitoring service is configured.
NOTE
Note that the IP address and port number monitored by the server should be consistent with those configured
on the client.
Only S5700EI and S5700HI support vpn-instance vpn-instance-name.
----End
6.12.3 Configuring the TCP Client
This part describes how to set TCP test parameters.
Quidway S5700 Series Ethernet Switches
Configuration Guide - Network Management 6 NQA Configuration
Issue 01 (2011-10-26) Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
281