1. Configure a Jitter test.
2. Configure the NQA thresholds.
3. Enable the function of sending trap messages.
4. Configure the function of sending trap messages to the NMS.
Data Preparation
To complete the configuration, you need the following data:
l IP address and port number of the server-side host.
l Type of the monitored service and monitoring port number
l RTD threshold and OWD threshold
l IP address of the NMS
Procedure
Step 1 Configure reachable routes between Switch A and Switch B, between Switch A and Switch C,
and between Switch B and Switch C. The configuration details are not mentioned here.
Step 2 Configure a Jitter test.
# Configure the IP address and UDP port number monitored by the NQA server on Switch C.
<SwitchC> system-view
[SwitchC] nqa-server udpecho 30.1.1.2 9000
# # Enable the NQA client on Switch A and create an NQA Jitter test on it.
<SwitchA> system-view
[SwitchA] nqa test-instance admin jitter
[SwitchA-nqa-admin-jitter] test-type jitter
[SwitchA-nqa-admin-jitter] destination-address ipv4 30.1.1.2
[SwitchA-nqa-admin-jitter] destination-port 9000
Step 3 Configure the NQA thresholds.
# Configure the RTD threshold on Switch A.
[SwitchA-nqa-admin-jitter] threshold rtd 20
Step 4 Enable the function of sending trap messages.
[SwitchA-nqa-admin-jitter] send-trap rtd
[SwitchA-nqa-admin-jitter] quit
Step 5 Configure the function of sending trap messages to the NMS.
[SwitchA] snmp-agent trap enable
[SwitchA] snmp-agent sys-info version v2c
[SwitchA] snmp-agent target-host trap address udp-domain 20.1.1.2 params
securityname public v2c
Step 6 Perform the test.
[SwitchA] nqa test-instance admin jitter
[SwitchA-nqa-admin-jitter] start now
[SwitchA-nqa-admin-jitter] quit
[SwitchA] quit
Step 7 Verify the configuration.
# Verify the NQA test result of each Switch.
Quidway S5700 Series Ethernet Switches
Configuration Guide - Network Management 6 NQA Configuration
Issue 01 (2011-10-26) Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
386
To Next Page
Loading...
