Huawei Quidway S5700 Series User Manual

# Disable NDP on the unrelated interfaces of member switches
[HUAWEI_0.Administrator-1] cluster
[HUAWEI_0.Administrator-1-cluster] undo cluster-member unrelated-port ndp
# Disable NTDP on the unrelated interfaces of member switches
[HUAWEI_0.Administrator-1] cluster
[HUAWEI_0.Administrator-1-cluster] undo cluster-member unrelated-port ntdp
Step 11 Verify the configuration.
After the previous configuration, run the display member-interface-state command on
administrator switch to check whether NDP or NTDP is disabled on unrelated interfaces of the
member switches, and you can view that success is displayed.
[HUAWEI_0.Administrator-1] display member-interface-state ndp
The result of member switches executed disable member interface command:
------------------------------------------------------------------------------
SN Device MacAddress IpAddress result
------------------------------------------------------------------------------
3 S5700 0004-0004-0004 10.0.0.4 success
2 S5700 0003-0003-0003 10.0.0.3 success
1 S5700 0002-0002-0002 10.0.0.2 success
[HUAWEI_0.Administrator-1] display member-interface-state ntdp
The result of member switches executed disable member interface command:
------------------------------------------------------------------------------
SN Device MacAddress IpAddress result
------------------------------------------------------------------------------
3 S5700 0004-0004-0004 10.0.0.4 success
2 S5700 0003-0003-0003 10.0.0.3 success
1 S5700 0002-0002-0002 10.0.0.2 success
----End
Configuration Files
l Configuration file of Administrator-1.
#
sysname Administrator-1
#
vlan batch 10
#
cluster enable
ntdp enable
ntdp hop 3
ntdp timer 10
ndp enable
#
interface Vlanif10
ip address 1.0.0.1 255.0.0.0
#
interface GigabitEthernet0/0/1
port link-type trunk
port trunk allow-pass vlan 10
ntdp enable
ndp enable
#
interface GigabitEthernet0/0/2
port link-type trunk
port trunk allow-pass vlan 10
ntdp enable
ndp enable
#
interface GigabitEthernet0/0/3
port link-type trunk
port trunk allow-pass vlan 10
#
cluster
mngvlanid 10
ip-pool 10.0.0.1 255.0.0.0
Quidway S5700 Series Ethernet Switches
Configuration Guide - Network Management 3 HGMP Configuration
Issue 01 (2011-10-26) Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
206

Huawei Quidway S5700 Series Specifications

General

Category	Switch
Operating Temperature	0°C to 45°C
Relative Humidity	5% to 95% (non-condensing)
Series	Quidway S5700
Forwarding Performance	Up to 96 Mpps
Ports	24 or 48 x 10/100/1000Base-T ports
Power Supply	AC or DC
Storage Temperature	-40°C to 70°C
Fixed GE Ports	24 or 48
Uplink Ports	4 x GE SFP ports
Routing Protocols	RIP, OSPF, BGP
Management	SNMP, RMON, CLI, Web
VLAN	4094 VLANs
PoE	Optional