Create service flows. Set the service VLAN to 300, GEM port ID to 12, and user VLAN to 300,
and use traffic profile ftth_voip.
huawei(config)#service-port vlan 300 gpon 0/1/0 ont 1 gemport 12 multi-service
user-vlan 300 inbound traffic-table name ftth_voip outbound traffic-table name
ftth_voip
huawei(config)#service-port vlan 300 gpon 0/1/0 ont 2 gemport 12 multi-service
user-vlan 300 inbound traffic-table name ftth_voip outbound traffic-table name
ftth_voip
Scenario 2:
Configure the mapping relationship between a GEM port and a VLAN. The service flow of user
VLAN 3001 is mapped to GEM port 12 in the ONT line profile.
huawei(config)#ont-lineprofile gpon profile-name ftth
huawei(config-gpon-lineprofile-1)#gem mapping 12 2 vlan 3001
huawei(config-gpon-lineprofile-1)#commit
huawei(config-gpon-lineprofile-1)#quit
Create a service VLAN and add an upstream port to it. Add upstream port 0/19/0 to VLAN 300.
huawei(config)#vlan 300 smart
huawei(config)#vlan attrib 300 stacking
huawei(config)#port vlan 300 0/19 0
Create service flows. Set the service VLAN to 300, GEM port ID to 12, and user VLAN to 3001.
Use traffic profile ftth_voip.
huawei(config)#service-port vlan 300 gpon 0/1/0 ont 1 gemport 12 multi-service
user-vlan 3001 tag-transform translate inbound traffic-table name ftth_voip
outboun
d traffic-table name ftth_voip
huawei(config)#service-port vlan 300 gpon 0/1/0 ont 2 gemport 12 multi-service
user-vlan 3001 tag-transform translate inbound traffic-table name ftth_voip
outboun
d traffic-table name ftth_voip
Step 9 Configure ONT voice service profiles.
ONT voice service profiles include the interface common profile, MGC interface profile, and
POTS port profile.
l Interface common profile: saves common attributes of an ONT voice interface, including the
fax mode, fax/modem negotiation mode, and priority of the coding and decoding mode.
l MGC interface profile: saves the IP address or domain name of the MGC, protocol port ID
of the MGC transport layer to which the MG interface belongs, and DSCP priority of media
packets.
l POTS port profile: saves physical attributes of a POTS port on an ONT, including the
impedance, transmitting gain, receiving gain, and signaling type of the POTS port.
1. Configure an interface common profile.
Run the display ont-mg-attribute-profile command to query the existing interface
common profile in the system. If the existing interface common profile in the system does
not meet the requirements, run the ont-mg-attribute-profile add command to add an
interface common profile.
In this example, the default interface common profile, namely interface common profile 1
is used.
2. Configure an MGC interface profile.
SmartAX MA5600T/MA5603T/MA5608T Multi-service
Access Module
Commissioning and Configuration Guide
19 IPv6 Configuration
Issue 01 (2014-04-30) Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
1948
To Next Page
Loading...
