IAI PCON-CB series User Manual

4. Operation
4.3 Pulse Train Control Mode
4-122 ME0342-4B
Caution
● Do not set the minimum movement unit out of the encoder resolution ability. If this
setting is conducted, the actuator would not start moving until enough command pulse
is stored in the encoder resolution error.
Caution
● Pay attention not to exceed the specification limit when setting the velocity, acceleration
and deceleration.
● The pressing operation velocity should be set to the rated pressing velocity described in
[9.4 List of Specifications of Connectable Actuators] when it is to conduct the pressing
operation.
Encoder resolution for linear axis [mm/pulse]
=
Ball Screw Lead Length [mm/rev]
No. of Encoder Pluses [pulse/rev]
=
No. of Encoder Pluses [pulse/rev]

IAI PCON-CB series Specifications

General

Brand	IAI
Model	PCON-CB series
Category	Controller
Language	English