JBL SDP-75 - Page 63

62
The following settings can be configured for each of your Source Configurations:
• Input Connectors: select the rear panel input(s) to which your source is connected.
o Clock:
o Default: the clock will run in master mode for analog inputs, in slave mode for digital inputs, and
in master mode for the network input.
o Mast. Xk: set the clock to different master clock sampling rates (32 kHz, 44.1 kHz, 48 kHz, 88.2
kHz or 96 kHz).
o Sl. WC: set the clock to slave mode.
• Output Connectors: select the outputs that you want to use to play this source:
o Analog + AES 1-8: analog outputs 1-32 ( depending upon your configuration ) and AES outputs
1-8 are active simultaneously;
o AES 1-16: AES outputs 1-16 are active; analog outputs are disabled;
o AML: Audio Multi Link is active;
o HDMI: HDMI outputs 1 & 2 are active simultaneously;
o AES OLD 1-16: old routing used in the prerelease models. Do not use.
• Digital Input Data:
o Auto-detect: automatically detect whether the input is PCM or bitstream;
o Force PCM Audio: force the PCM audio format;
o Force Bitstream Data: force the bitstream format to let the SDP-75 decode the signal from the
player.
• Channels: On a non-HDMI source, you can select the channels you want to play.
o L,R
o L,R,C
o L,R,C,Lfe
o L,R,C,Lfe,Ls,Rs
o L,R,C,Lfe,Ls,Rs,Lrs,Rrs
• Listening Format: Select the default format you want to use with this source. The SDP-75 will be forced to
decode and up-mix (if possible) in this format.
o Auto : Will automatically up-mix in the corresponding format
o Dolby Surround : Will force the Dolby Surround up-mix
o Neural:X : Will force the DTS Neural:X up-mix
o Auro-3D: Will force the Auro-3D up-mix.
o Native : keeps the incoming format from the source
o Up-mix on native : Will automatically up-mix in the corresponding format with the Legacy layout
o Legacy : Will only use the bed (5.1 or 7.1)
• Default Preset: This parameter allows you to link a source to one of the presets you created.
o No Change: no preset is associated to this source configuration;
o Select Preset number 1 to 29: Choose one of the 29 presets to load a preset when this source is
selected.
• The following parameters are set, by default, to use the settings from the current preset:
• Source (the format of the source)
• FIR EQ : Select a FIR EQ that has been saved in the Processor/Output page.
• User EQ : Select a FIR EQ that has been saved in the Processor/Output page.
• Input Levels
• Output Delays
• The Master Level can be left Unchanged (default setting) or set to a specific level.
• Power-on Default: the selected source can be set as the default configuration to be loaded at power-on.
Alternatively, you can check the option Use last loaded source as power-on default source in order to keep the
source that was used before the last shut-down.