70
6 OVERVIEW OF THE SETUP
PROCEDURE
The following summary provides an overview of the overall setup procedure that must be followed
for a smooth and successful setup of the SDP-75 in a home theatre system.
A) Get ready for the installation
First of all, before you start, you must carefully read two key chapters that provide important information about
the SDP-75 tools and settings, as well as very important tips and recommendations to perform the acoustical
measurements:
1. Read the whole chapter about the SDP-75 Essential Tools and Settings;
2. Read the whole chapter Getting Ready for Calibration to get mandatory information on calibration
procedure.
B) Perform the installation
Once you’ve learned the tools & tips, you are ready to follow the setup procedure:
Please note: it is critically important to follow the steps in the specified order, otherwise the system will not
perform properly:
1. Specify the speaker layout in the SDP-75 graphic user interface: choose and configure the speaker layout.
Send pink noise to verify that the routing of the speakers is correct.
2. Optional: if one or more speakers require multi-amplification: configure, calibrate and verify the SDP-75’s
intelligent active crossovers.
3. Fine-tune the speaker system in the room:
a. Measure all the speakers with the SDP-75’s automated measurement and optimization tools;
b. Optional: if required, Setup Bass Management for multiple speakers;
4. Last but not least: verify the sound of the speaker system.
All these steps are explained in detail in the following chapters.
NOTE: the setup procedure of the SDP-75 can be performed:
• With a VNC Client connected to the SDP-75 through the network,
• With a display, a mouse and a keyboard directly connected to the SDP-75’s back panel.
However, the setup procedure cannot be performed with a web browser connected to the SDP-75’s web-based interface.
Further details about the web interface are provided in the Introduction chapter at the beginning of this document.
For a detailed step-by-step explanation of how to connect with a VNC Client, please see corresponding pages in the
Network Setup chapter. For additional details about connecting a display, a mouse and a keyboard, please refer to the
Introduction chapter at the beginning of this document.
To Next Page
Loading...
