JBL SDP-75 - Page 9

8
8.11# SEND PINK NOISE TO VERIFY THE ROUTING OF THE SPEAKERS ........................................................... 91#
8.12# SAVE THE PRESET ..................................................................................................................... 92#
9# SPECIFY AN ARRAY OF SPEAKERS .............................................................................................. 93#
9.1# SETTING UP AN ARRAY OF SPEAKERS ........................................................................................... 93#
9.2# EXAMPLE OF AN ARRAY OF SPEAKERS .......................................................................................... 94#
9.3# ADJUST THE GAIN ..................................................................................................................... 94#
9.4# SAVE THE PRESET .................................................................................................................... 95#
10# DECODER / UP-MIXER SETTINGS ................................................................................................ 96#
10.1# SUPPORTED DECODERS/UP-MIXERS ........................................................................................... 96#
10.2# LISTENING FORMATS ................................................................................................................ 97#
10.3# USING THE FRONT PANEL ......................................................................................................... 101#
# Listening format selection ...................................................................................................................... 101#
# Decoders Configuration .......................................................................................................................... 101#
10.4# USING THE GRAPHICAL INTERFACE ............................................................................................ 102#
# Listening formats selection .................................................................................................................... 102#
# Decoders Configuration .......................................................................................................................... 102#
10.5# DECODERS SETTINGS .............................................................................................................. 103#
# General Settings ..................................................................................................................................... 103#
# Dolby decoder settings ........................................................................................................................... 104#
# DTS decoder Settings ............................................................................................................................. 105#
# Auro-3D decoder settings ...................................................................................................................... 106#
11# GETTING READY FOR CALIBRATION .......................................................................................... 107#
11.1# VERY IMPORTANT TIPS ....................................................................................................... 107#
11.2# CHECKLIST BEFORE YOU START ................................................................................................. 107#
11.3# IMPORTANT RECOMMENDATIONS FOR MICROPHONE PLACEMENT .................................................... 108#
# Requirements for the measurement environment .................................................................................. 108#
# Reference measurement point ............................................................................................................... 108#
# Position and orientation of the microphone for the reference point ...................................................... 108#
12# CALIBRATE THE ACTIVE CROSSOVERS (OPTIONAL) ................................................................. 110#
12.1# OVERVIEW OF THE CROSSOVER SETUP PROCEDURE ....................................................................... 110#
12.2# CONFIGURE THE ADVANCED SETTINGS (OPTIONAL) ....................................................................... 111#
12.3# ADJUST THE MASTER OUTPUT LEVEL ......................................................................................... 113#
12.4# CALIBRATE THE ACTIVE CROSSOVERS ......................................................................................... 114#
12.5# VERIFY THE SOUND OF THE CALIBRATED CROSSOVERS .................................................................. 115#
# Visualize the acoustical graphs for each speaker .................................................................................. 115#
# Listen to each speaker connected to the crossover ............................................................................... 117#
12.6# SAVE THE PRESET ................................................................................................................... 117#
13# LEVEL AND DELAY CALIBRATION .............................................................................................. 118#
13.1# OVERVIEW OF THE CALIBRATION PROCEDURE ............................................................................... 118#
13.2# ADJUST THE MASTER OUTPUT LEVEL ......................................................................................... 118#
13.3# NORMAL CALIBRATION SEQUENCE ............................................................................................. 119#
13.4# COMMON PROBLEMS DURING CALIBRATION ................................................................................ 120#
13.5# CALIBRATION STATUS ............................................................................................................. 120#
13.6# CHECKING THE SPEAKER SUMMARY AFTER CALIBRATION ............................................................... 121#
13.7# MULTI-POINT MEASUREMENTS (OPTIONAL) ................................................................................ 124#
13.8# COMPUTE THE OPTIMIZATION FILTERS ....................................................................................... 124#
13.9# SAVE THE PRESET ................................................................................................................... 125#
14# SETUP BASS MANAGEMENT ...................................................................................................... 126#
14.1# OVERVIEW OF THE BASS MANAGEMENT SETUP PROCEDURE ............................................................ 126#
14.2# FULLY CUSTOMIZABLE BASS MANAGEMENT ................................................................................ 127#
14.3# BASS MANAGEMENT MODE ....................................................................................................... 128#
14.4# QUICK SETUP MENU ................................................................................................................ 130#
# Set Filters ................................................................................................................................................ 131#
# Apply to selected speakers ..................................................................................................................... 131#
14.5# BASS MANAGEMENT SETTINGS FOR INDIVIDUAL SPEAKER .......................................................... 132#
14.6# LFE & MISC .......................................................................................................................... 133#
# Low Frequency Effect Setup ................................................................................................................... 133#