Table 92: Traceroute field summary (continued)
Your ActionFunctionField
From the list, select the decimal value of the
TOS field.
Specifies the type-of-service (TOS) value to include in
the IP header of the traceroute request packet.
Type-of-Service
To display the AS numbers, select the check
box.
Determines whether the autonomous system (AS)
number of each intermediate hop between the router
and the destination host is displayed.
Resolve AS Numbers
Related
Documentation
Connecting and Configuring an EX Series Switch (CLI Procedure)•
• Connecting and Configuring an EX Series Switch (J-Web Procedure) on page 45
• Configuring Gigabit Ethernet Interfaces (J-Web Procedure) on page 109
• Monitoring Interface Status and Traffic on page 198
Monitoring DHCP Services
Purpose NOTE: This topic applies only to the J-Web Application package.
A switch or router can operate as a DHCP server. Use the monitoring functionality to view
information about dynamic and static DHCP leases, conflicts, pools, and statistics.
Action To monitor the DHCP server in the J-Web interface, select Monitor > Services > DHCP.
To monitor the DHCP server in the CLI, enter the following CLI commands:
• show system services dhcp binding
• show system services dhcp conflict
• show system services dhcp pool
• show system services dhcp statistics
• show system services dhcp relay-statistics
• show system services dhcp global
• show system services dhcp client
• clear system services dhcp binding
• clear system services dhcp conflict
• clear system services dhcp statistics
• clear dhcp relay-statistics
205Copyright © 2017, Juniper Networks, Inc.
Chapter 16: Monitoring Tasks
To Next Page
Loading...
