Juniper EX Series - Chapter 8 Ethernet Switching Configuration; Configuring Vlans for EX Series Switches (J-Web Procedure)

CHAPTER 8
Ethernet Switching Configuration
•
Configuring VLANs for EX Series Switches (J-Web Procedure) on page 97
•
Configuring Spanning Tree Protocols (J-Web Procedure) on page 100
•
Configuring IGMP Snooping (J-Web Procedure) on page 104
•
Configuring Redundant Trunk Groups (J-Web Procedure) on page 106
Configuring VLANs for EX Series Switches (J-Web Procedure)
NOTE: This topic applies only to the J-Web Application package.
You can use the VLAN Configuration page to add a new VLAN or to edit or delete an
existing VLAN on an EX Series switch.
To access the VLAN Configuration page:
1. Select Configure > Switching > VLAN.
The VLAN Configuration page displays a list of existing VLANs. If you select a specific
VLAN, the specific VLAN details are displayed in the Details section.
NOTE: After you make changes to the configuration on this page, you
must commit the changes immediately for them to take effect. To commit
all changes to the active configuration, select Commit Options > Commit.
See Using the Commit Options to Commit Configuration Changes for
details about all commit options.
2. Click one of the following options:
•
Add—Creates a VLAN.
•
Edit—Edits an existing VLAN configuration.
•
Delete—Deletes an existing VLAN.
97Copyright © 2017, Juniper Networks, Inc.