Juniper EX Series - Configuring Redundant Trunk Groups (J-Web Procedure)

•
Term Up—Moves a term up in the list.
•
Term Down—Moves a term down in the list.
•
Delete—Deletes the selected policy.
•
Test Policy—Tests the policy. Use this option to check whether the policy produces
the results that you expect.
Table 47: Policies Global Configuration Parameters
Your ActionFunctionField
To add a prefix list:
1. Click Add.
2. Enter a name for the prefix list.
3. To add an IP address, click Add.
4. Enter the IP address and the subnet mask and click OK.
5. Click OK.
To edit a prefix list, click Edit. Edit the settings and click OK.
To delete a prefix list, select it and click Delete.
Specifies a list of IPv4 address
prefixes for use in a routing policy
statement.
Prefix List
To add a BGP community:
1. Click Add.
2. Enter a name for the community.
3. To add a community, click Add.
4. Enter the community ID and click OK.
5. Click OK.
To edit a BGP community, click Edit. Edit the settings and click OK.
To delete a BGP community, select it and click Delete.
Specifies a BGP community.BGP
Community
Copyright © 2017, Juniper Networks, Inc.86
J-Web Application Package User Guide for EX Series Switches, Release 14.1X53-A1