CHAPTER 11
Configuring Layer 3 Protocols
•
Configuring BGP Sessions (J-Web Procedure) on page 135
•
Configuring an OSPF Network (J-Web Procedure) on page 139
•
Configuring a RIP Network (J-Web Procedure) on page 144
•
Configuring Static Routing (J-Web Procedure) on page 148
Configuring BGP Sessions (J-Web Procedure)
NOTE: This topic applies only to the J-Web Application package.
You can use the J-Web interface to create BGP peering sessions on a routing device.
NOTE: To configure BGP sessions, you must have a license for BGP installed
on the EX Series switch.
To configure a BGP peering session:
1. Select Configure > Routing > BGP.
NOTE: After you make changes to the configuration on this page, you
must commit the changes for them to take effect. To commit all changes
to the active configuration, select Commit Options > Commit. See Using
the Commit Options to Commit Configuration Changes for details about
all commit options.
2. Click one of the following options:
•
Add—Adds a BGP group. Enter information into the configuration page as described
in Table 68 on page 136.
•
Edit—Modifies an existing BGP group. Enter information into the configuration page
as described in Table 68 on page 136.
135Copyright © 2017, Juniper Networks, Inc.
To Next Page
Loading...
