Juniper EX Series User Manual

Table 100: Summary of Key Routing Information Output Fields (continued)
Additional InformationValuesField
The route preference is used as one of the route
selection criteria.
The preference is the individual preference value for
the route.
Preference
If a next hop is listed as Discard, all traffic with that
destination address is discarded rather than routed.
This value generally means that the route is a static
route for which the discard attribute has been set.
If a next hop is listed as Reject, all traffic with that
destination address is rejected. This value generally
means that the address is unreachable. For example,
if the address is a configured interface address and the
interface is unavailable, traffic bound for that address
is rejected.
If a next hop is listed as Local, the destination is an
address on the host (either the loopback address or
Ethernet management port 0 address, for example).
Network layer address of the directly reachable
neighboring system (if applicable) and the interface
used to reach it.
Next-Hop
How long the route has been active.Age
There are many possible flags.Flags for this route.State
AS path through which the route was learned. The
letters of the AS path indicate the path origin:
• I—IGP.
• E—EGP.
• ?—Incomplete. Typically, the AS path was
aggregated.
AS Path
Related
Documentation
Configuring Static Routing (J-Web Procedure) on page 148•
• Configuring Static Routing (CLI Procedure)
• Layer 3 Protocols Supported on EX Series Switches
Monitoring Ethernet Switching
Purpose NOTE: This topic applies only to the J-Web Application package.
Use the monitoring feature to view details that the EX Series switch maintains in its
Ethernet switching table. These are details about the nodes on the LAN, such as VLAN
name, VLAN ID, member interfaces, MAC addresses, and so on.
217Copyright © 2017, Juniper Networks, Inc.
Chapter 16: Monitoring Tasks

Juniper EX Series Specifications

General

Series	EX Series
Category	Switch
Layer	Layer 2/3
Operating System	Junos OS
Managed	Yes
ACLs	Yes
Port Density	Varies by model
Power over Ethernet (PoE)	Available on some models
Virtual Chassis	Supported on some models
Form Factor	Fixed configuration, Modular
Switching Capacity	Varies by model
Forwarding Rate	Varies by model
Power Supply	Varies by model (AC or DC, redundant options available)
Management	CLI, Web UI, SNMP
Redundancy	Power supply, fan, Virtual Chassis
Latency	Varies by model
Jumbo Frames	Supported
VLAN Support	Yes
MAC Address Table Size	Varies by model
QoS	Yes
Energy Efficiency	EEE (802.3az)
Dimensions	Varies by model
Weight	Varies by model
Operating Temperature	0° to 45° C
Storage Temperature	-40° to 70° C
Humidity	5% to 90% non-condensing
MTBF	Varies by model
Warranty	Limited Lifetime