Juniper EX Series - Configuring Management Access for the EX Series Switch; Procedure); Table 30: Secure Management Access Configuration Summary; Configuring Management Access for the EX Series Switch (J-Web Procedure)

Related
Documentation
Configuring Date and Time for the EX Series Switch (J-Web Procedure) on page 50•
Configuring Management Access for the EX Series Switch (J-Web Procedure)
You can manage an EX Series switch remotely through the J-Web interface. To
communicate with the switch, the J-Web interface uses HTTP. HTTP enables easy Web
access, but uses no encryption. The data that is transmitted between the Web browser
and the switch by means of HTTP is vulnerable to interception and attack. To enable
secure Web access the switch supports HTTPS. You can enable HTTP or HTTPS access
on specific interfaces and ports as needed.
Navigate to the Secure Access Configuration page by selecting Configure > System
Properties > Management Access. On this page, you can enable HTTP and HTTPS access
on interfaces for managing the EX Series switch through the J-Web interface. You can
also install SSL certificates and enable Junos XML management protocol over SSL with
the Secure Access page.
1. Click Edit to modify the configuration. Enter information into the Management Access
Configuration page as described in Table 30 on page 52.
2. To verify that Web access is enabled correctly, connect to the switch using the
appropriate method:
•
For HTTP access—In your Web browser, type http://URL or http://IP address.
•
For HTTPS access—In your Web browser, type https://URL or https://IP address.
•
For SSL Junos XML management protocol access—To use this option, you must
have a Junos XML management protocol client such as Junos Scope. For information
about how to log in to Junos Scope, see the Junos Scope Software User Guide.
NOTE: After you make changes to the configuration on this page, you
must commit the changes for them to take effect. To commit all changes
to the active configuration, select Commit Options > Commit. See Using
the Commit Options to Commit Configuration Changes for details about
all commit options.
Table 30: Secure Management Access Configuration Summary
Your ActionFunctionField
Management Access tab
Copyright © 2017, Juniper Networks, Inc.52
J-Web Application Package User Guide for EX Series Switches, Release 14.1X53-A1