Juniper EX Series - Table 32: Classifiers Configuration Fields

You can use the J-Web interface to define CoS classifiers on an EX Series switch.
Classifiers examine the CoS value or alias of an incoming packet and assign the packet
a level of service by setting its forwarding class and loss priority.
To define CoS classifiers:
1. Select Configure > Class of Service > Classifiers.
NOTE: After you make changes to the configuration on this page, you
must commit the changes immediately for them to take effect. To commit
all changes to the active configuration, select Commit Options > Commit.
See “Using the Commit Options to Commit Configuration Changes (J-Web
Procedure)” on page 31 for details about all commit options.
2. Click one of the following options:
•
Add—Adds a classifier. Enter information into the classifier page as described in
Table 32 on page 61.
•
Edit—Modifies an existing classifier. Enter information into the classifier page as
described in Table 32 on page 61.
•
Delete—Deletes an existing classifier.
Table 32: Classifiers Configuration Fields
Your ActionFunctionField
To name a classifier, type the name—for
example, ba-classifier.
Specifies the name for a classifier.Classifier Name
Select a value from the list.Specifies the type of classifier: dscp, ieee-802.1,
or inet-precedence.
Classifier Type
61Copyright © 2017, Juniper Networks, Inc.
Chapter 5: Class of Service Configuration