Juniper EX Series User Manual

CHAPTER 2
Starting J-Web
•
Starting the J-Web Interface on page 37
Starting the J-Web Interface
You can use the J-Web interface to configure and manage the EX Series switch.
To start the J-Web interface:
1. Launch your HTTP-enabled or HTTPS-enabled Web browser.
To use HTTPS, you must have installed a certificate on the switch and enabled HTTPS.
2. After http:// or https:// in your Web browser, type the hostname or IP address of the
switch and press Enter.
The J-Web login page appears.
3. On the login page, type your username and password, and click Login.
NOTE: The default username is root with no password. You must change
this during initial configuration or the system does not accept the
configuration.
If you are using an Application package of J-Web, the Dashboard information page
appears; if you are using a Platform package of J-Web, the Configure Options page
appears.
To explicitly terminate a J-Web session at any time, click Logout in the top pane.
Related
Documentation
• J-Web User Interface for EX Series Switches Overview on page 3
• Dashboard for EX Series Switches on page 9
37Copyright © 2017, Juniper Networks, Inc.

Juniper EX Series Specifications

General

Series	EX Series
Category	Switch
Layer	Layer 2/3
Operating System	Junos OS
Managed	Yes
ACLs	Yes
Port Density	Varies by model
Power over Ethernet (PoE)	Available on some models
Virtual Chassis	Supported on some models
Form Factor	Fixed configuration, Modular
Switching Capacity	Varies by model
Forwarding Rate	Varies by model
Power Supply	Varies by model (AC or DC, redundant options available)
Management	CLI, Web UI, SNMP
Redundancy	Power supply, fan, Virtual Chassis
Latency	Varies by model
Jumbo Frames	Supported
VLAN Support	Yes
MAC Address Table Size	Varies by model
QoS	Yes
Energy Efficiency	EEE (802.3az)
Dimensions	Varies by model
Weight	Varies by model
Operating Temperature	0° to 45° C
Storage Temperature	-40° to 70° C
Humidity	5% to 90% non-condensing
MTBF	Varies by model
Warranty	Limited Lifetime